Sony Security Camera SNT EP154 User Manual

4-154-545-11 (1)  
Notes on Use  
Specifications  
Compression  
Before Use  
Video compression format  
Audio compression format  
Maximum frame rate  
JPEG/MPEG4/H.264  
G.711/G.726 (40, 32, 24, 16 kbps)  
30 fps  
If you find condensation when you open the package, turn on the power after  
leaving it for about 60 minutes.  
Data and security  
You should keep in mind that the images or audio you are monitoring may be  
protected by privacy and other legal rights, and the responsibility for making  
sure you are complying with applicable laws is yours alone.  
Interface  
Network port  
10BASE-T/100BASE-TX, auto negotiation (RJ-45)  
Sensor input : × 4  
Alarm output : × 4  
(electrically isolated from the unit)  
Camera control interface: ×1 (RS-485)  
Video Network Station  
I/O port (Only SNT-EX154)  
Access to the images and audio is protected only by a user name and the  
password you set up. No further authentication is provided nor should you  
presume that any other protective filtering is done by the service. Since  
the service is Internet-based, there is a risk that the image or audio you are  
monitoring can be viewed or used by a third-party via the network.  
SONY IS NOT RESPONSIBLE, AND ASSUMES ABSOLUTELY NO LIABILITY TO YOU  
OR ANYONE ELSE, FOR SERVICE INTERRUPTIONS OR DISCONTINUATIONS OR  
EVEN SERVICE CANCELLATION. THE SERVICE IS PROVIDED AS-IS, AND SONY  
DISCLAIMS AND EXCLUDES ALL WARRANTIES, EXPRESS OR IMPLIED, WITH  
RESPECT TO THE SERVICE INCLUDING, BUT NOT LIMITED TO, ANY OR ALL  
IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR  
PURPOSE, OR THAT IT WILL OPERATE ERROR-FREE OR CONTINUOUSLY.  
Security configuration is essential for wireless LAN. Should a problem  
occur without setting security, or due to the limitation of the wireless LAN  
specifications, SONY shall not be liable for any damage, loss of recorded data  
or restoration thereof.  
Installation Manual  
Before operating the unit, please read this manual thoroughly and  
retain it for future reference.  
Microphone input/Line input (switchable by setting) (Only SNT-EX154)  
Mini-jack (monaural)  
Microphone input: Supports plug-in power system  
(reference voltage 2.5 V DC)  
Minijack (monaural) (SNT-EX154 only)  
Line output  
Others  
Power supply  
12 V DC (From SNT-RS1U/RS3U)  
0 °C to +45 °C (32 °F to 113 °F)  
–20 °C to +60 °C (–4 °F to +140 °F)  
20% to 80%  
SNT-EX154  
Operating temperature  
Storage temperature  
Operating humidity  
Storage humidity  
Dimensions  
Mass  
20% to 80%  
78 × 34 × 382 mm (3 1/8 × 1 3/8 × 15 1/8 inches) (w/h/d)  
Approx. 0.4 kg (14 oz)  
Supplied accessories  
Installation Manual (this document) (1)  
B&P Warranty Booklet (1)  
Always make a test recording, and verify that it was recorded successfully.  
SONY WILL NOT BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT  
LIMITED TO, COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF FAILURE  
OF THIS UNIT OR ITS RECORDING MEDIA, EXTERNAL STORAGE SYSTEMS OR  
ANY OTHER MEDIA OR STORAGE SYSTEMS TO RECORD CONTENT OF ANY TYPE.  
Always verify that the unit is operating properly before use. SONY WILL NOT  
BE LIABLE FOR DAMAGES OF ANY KIND INCLUDING, BUT NOT LIMITED TO,  
COMPENSATION OR REIMBURSEMENT ON ACCOUNT OF THE LOSS OF PRESENT  
OR PROSPECTIVE PROFITS DUE TO FAILURE OF THIS UNIT, EITHER DURING THE  
WARRANTY PERIOD OR AFTER EXPIRATION OF THE WARRANTY, OR FOR ANY  
OTHER REASON WHATSOEVER.  
I/O port connector (Only SNT-EX154) (1)  
Attachment screws (2)  
SNT-EX154  
SNT-EP154  
Design and specifications are subject to change without notice.  
Recommendation of Periodic Inspections  
In case using this device over an extended period of time, please have it  
inspected periodically for safe use.  
It may appear flawless, but the components may have deteriorated over time,  
which may cause a malfunction or accident.  
2009 Sony Corporation Printed in China  
SNT-EP154  
If you lose data by using this unit, SONY accepts no responsibility for  
restoration of the data.  
For details, please consult the store of purchase or an authorised Sony dealer.  
Personal information  
Owners Record  
The images taken by the system using this device can identify individuals  
and thus they fall under “personal informationstipulated in the “Act on  
the Protection of Personal Information. Please handle the video data  
appropriately according to law.  
The model and serial numbers are located on the bottom of the unit. Record  
these numbers in the spaces provided below.  
Refer to these numbers whenever you call upon your Sony dealer regarding  
this product.  
Information recorded using this product may also be “personal information.  
Upon disposal, transfer, repair, or any other occasion where this product or  
storage media is passed on to a third party, practice due care in its handling.  
Model No.  
Serial No.  
Operating or storage location  
Avoid operating or storing the camera in the following locations.  
Extremely hot or cold places (Operating temperature: 0 °C to +45 °C [32 °F to  
113 °F])  
Exposed to direct sunlight for a long time, or close to heating equipment (e.g.,  
near heaters)  
Close to sources of strong magnetism  
Close to sources of powerful electromagnetic radiation, such as radios or TV  
transmitters  
Locations subject to strong vibration or shock  
WARNING  
To reduce a risk of fire or electric shock, do not expose  
this product to rain or moisture.  
To avoid electrical shock, do not open the cabinet. Refer  
servicing to qualified personnel only.  
WARNING  
Ventilation  
This installation should be made by a qualified service person and should  
conform to all local codes.  
To prevent heat buildup, do not block air circulation around the unit.  
Transportation  
Always turn off the power when carrying.  
When transporting the unit, repack it as originally packed at the factory or in  
materials of equal quality.  
IMPORTANT  
The nameplate is located on the bottom.  
77  
CAUTION  
(3 1/8)  
These servicing instructions are for use by qualified personnel only. To  
reduce the risk of electric shock, do not perform any servicing other than  
that contained in the Operating Instructions unless you are qualified to do  
so.  
Cleaning  
Use a soft, dry cloth to clean the external surfaces of the unit. Stubborn  
stains can be removed using a soft cloth dampened with a small quantity of  
detergent solution, then wipe dry.  
Refer all servicing to qualified service personnel.  
Do not use volatile solvents such as alcohol, benzene or thinners as they may  
damage the surface finishes.  
For customers in the U.S.A.  
Please consult the store of purchase or authorized Sony dealer if there were  
troubles and anomalies.  
This device complies with Part 15 of the FCC Rules. Operation is subject  
to the following two conditions: (1) This device may not cause harmful  
interference, and (2) this device must accept any interference received,  
including interference that may cause undesired operation.  
About the Supplied Manuals  
Installation Manual (this document)  
NOTE: This equipment has been tested and found to comply with the limits  
for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits  
are designed to provide reasonable protection against harmful interference  
when the equipment is operated in a commercial environment. This  
equipment generates, uses, and can radiate radio frequency energy and, if  
not installed and used in accordance with the instruction manual, may cause  
harmful interference to radio communications. Operation of this equipment  
in a residential area is likely to cause harmful interference in which case the  
user will be required to correct the interference at his own expense.  
This Installation Manual describes the names and functions of parts and controls  
of the Video Network Station. Be sure to read the Installation Manual before  
operating.  
Note  
This product is used by installing it to the SNT-RS1U/SNT-RS3U.  
See the Installation Manual of the SNT-RS1U/SNT-RS3U and User’s guide of the  
unit for installation and use.  
You are cautioned that any changes or modifications not expressly approved  
in this manual could void your authority to operate this equipment.  
Location and Function of Part  
All interface cables used to connect peripherals must be shielded in order to  
comply with the limits for a digital device pursuant to Subpart B or Part 15 of  
FCC Rules.  
Rear  
78  
78  
I/O (Input/Output) port  
(3 1/8)  
(3 1/8)  
This device is provided with an RS-485 port, four sensor inputs and four alarm  
outputs.  
For customers in Canada  
This Class A digital apparatus complies with Canadian ICES-003.  
Pin No.  
Indication  
Functions  
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du  
Canada.  
1
2
C
1
2
3
4
1
2
3
4
G
Common terminal for alarm output  
Alarm output 1 (floating)  
SNT-EP154  
SNT-EX154  
Unit: mm (inches)  
For the customers in Europe  
The manufacturer of this product is Sony Corporation, 1-7-1 Konan, Minato-  
ku, Tokyo, Japan.  
The Authorized Representative for EMC and product safety is Sony  
Deutschland GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, Germany.  
For any service or guarantee matters please refer to the addresses given in  
separate service or guarantee documents.  
ALARM  
OUT  
3
Alarm output 2 (floating)  
4
Alarm output 3 (floating)  
5
Alarm output 4 (floating)  
6
Alarm input 1 (GND level reference)  
Alarm input 2 (GND level reference)  
Alarm input 3 (GND level reference)  
Alarm input 4 (GND level reference)  
ALARM IN/RS-485 reference GND  
7
For the customers in Europe, Australia and New Zealand  
8
WARNING  
9
ALARM IN  
/RS-485  
This is a Class A product. In a domestic environment, this product may cause  
radio interference in which case the user may be required to take adequate  
measures.  
10  
RS-485 (+) input/output (GND level  
reference)  
11  
12  
+
In the case that interference should occur, consult your nearest authorized  
Sony service facility.  
This apparatus shall not be used in the residential area.  
RS-485 (–) input/output (GND level  
reference)  
.
LAN (network) port (RJ45)  
Connect to the 10BASE-T or 100BASE-TX network using a network cable (UTP,  
category 5).  
CAUTION  
For safety, do not connect the connector for peripheral device wiring that  
might have excessive voltage to this port. Follow the instructions for this  
port.  
When you connect the LAN cable of the unit to peripheral device, use a  
shielded-type cable to prevent malfunction due to radiation noise.  
(microphone input/line input) terminal (min-ijack, monaural)  
Connect a commercially-available microphone when using the microphone  
input.  
The plug-in power system (reference voltage 2.5 V DC) is supported. Input  
between microphone and line input is user-switchable.  
Video input terminal (BNC)  
Input composite video signal.  
(line output) terminal (minijack, monaural)  
Connect to a speaker with a built-in amplifier.  
On-board  
Video signal terminating resistor switch  
Switches 1 to 4 respectively, corresponding to video input terminals 1 to 4.  
Note  
Always turn on the switch when using Coaxitron® (SNT-EX154 only). The device  
does not operate with the switch off.  
 

Sharp Air Conditioner AE X24LCJ User Manual
Sony Camera Accessories aws g500 User Manual
Sony Projector VPL CX75 User Manual
Sony Projector VPL W400QM User Manual
Sony Stereo Amplifier TA AV561A User Manual
SoundCraft Home Security System RK 65K User Manual
StarTechcom Computer Drive ST4300USB3 User Manual
StarTechcom Switch SV431H User Manual
Stiga Lawn Mower 8211 3417 05 User Manual
Super Talent Technology Computer Drive AES 256 User Manual